Total cost of ownership describes the total cost of a component over its service life, not just the purchase price. For a corrugating roll, these costs are made up of several items: purchase, changeover effort, production losses during operation and reconditioning. Only the first appears on the quote. The others arise at your plant, spread over years, and never show up in a price comparison.
| Cost item | When it arises | What influences it |
|---|---|---|
| Purchase | Once | Material, coating, profile design |
| Roll change | Per change interval | Roll service life, installation time, storage requirements |
| Downtime costs | Per downtime | Duration of the change, duration of the restart |
| Waste after start-up | Per production stop | Condensate removal |
| Quality towards end of life | Over the service life | Dimensional stability of profile and caliper |
| Reconditioning | Per regrind | Number of possible regrinds |
Over the life of a set, our rolls usually allow four, in some cases even five, regrinds instead of three. That is an additional service life cycle from the same set.
Send us your data. You will receive a calculation for your line, not a sample calculation. And if a switch does not pay off, we will tell you that too.
The question behind all the others is: when does the higher-spec roll pay off? The answer depends on your capacity utilisation, which is why we calculate it specifically rather than across the board.
Total cost of ownership covers all costs over the life of a roll set: purchase, roll changes, production losses and reconditioning. The purchase price is just one of several items.
Over the life of a set, our rolls usually allow four, in some cases even five, regrinds instead of three.