Pressure rolls

Pressure in the single facer

Request a roll
Consultation

What the pressure roll is for.

In brief

The pressure roll presses the liner against the glued fluting web on the corrugating roll so that the flute tips bond cleanly. If its geometry is no longer exact, the pressure is distributed unevenly across the web width. You see that on the finished sheet before you see it on the roll.

Three points that count.

What's in it for you

Quality

We manufacture pressure rolls to all pressure vessel certifications and from high-grade quenched and tempered steel.

Cylindrical or crowned

Exact crown curve across the full width.

Repair including bearing seat

We rebuild damaged bearing seats to OEM dimensions by tungsten spraying, and seal seats with tungsten carbide.

Versions at a glance.

Technical data
Feature Value
Versions Cylindrical, crowned
Testing CE, ASME
Concentricity 20 µm
Max. roll body dimensions ø 620 × 3,000 mm
Max. weight 3.5 t

From damage to decision.

When something is damaged

1

Inspection

We check the roll body, bearing seat, seal seat and surface. If required, also a pressure test and crack testing.

2

Assessment

You receive an assessment of what can be repaired and what cannot.

3

Quote

After the inspection, each repair scope is calculated individually and quoted separately.

4

Repair

Bearing seats rebuilt to OEM dimensions by tungsten spraying, seal seats with tungsten carbide, surfaces with improved mechanical properties.

Send us the key data.

Your enquiry

Machine type, working width and version are enough for an initial proposal. In the event of damage, photos help most; then we can assess in advance whether a repair is worthwhile.

What is the sum of 9 and 9?

Pressure, approval, repair.

Frequently asked questions.

Most questions about pressure rolls concern the version and whether a damaged roll can still be saved. If in doubt, send us photos; that saves both sides a site visit.

It is heated with high-energy saturated steam and is under internal pressure. That is why we manufacture and test pressure rolls to all common approvals.

In many cases, yes. We rebuild the seat to OEM dimensions by tungsten spraying. However, if the bearing damage was detected too late and material and thread areas have been worn away, we cannot offer a repair with guaranteed success.

Pressure marks of varying intensity across the full width become visible on the liner.