Corrugating rolls for your line.

Our core product

Send machine data
Consultation
Two corrugating rolls mesh and form the flute profile

What a corrugating roll does.

In brief

A corrugating roll turns flat paper into the flute that gives corrugated board its stiffness. In the single facer, two of them always work against each other: heated, under pressure and at high speed. Their geometry determines how much paper is consumed and how stable the finished board is. Their surface determines how long it stays that way. That is why the corrugating roll is the most heavily stressed component in the corrugator and the one with the clearest impact on cost efficiency.

Four effects in operation.

What's in it for you

One more regrind

Over the life of a set, our rolls usually allow four, in some cases even five, regrinds instead of three.

Caliper holds

Profile geometry and board quality are maintained until the end of the set's life.

Less friction

Lower friction during fluting and less loss of strength.

Less budget

Because the set runs longer, you need less budget.
Profile analysis of a corrugating roll at Friese GmbH

Measure first, then manufacture.

PACE profile analysis

Before we build a roll, we look at the existing one. In the PACE profile analysis, we compare your current profile with a proposal for a new one. At the same time, we check which coating suits the papers and the single facer actually running at your plant. You get the comparison and make the decision.

Request a profile analysis

What we can manufacture.

Technical data
Feature Value
Concentricity 20 µm
Flute profiles designed in our archive 140,000, from 0.50 mm to 10.00 mm flute height
Known single facer types 104
Surface hardening Induction or nitride hardening
Heating Conventional, peripheral or Thermogrooves
Coating Tungsten carbide (ROCKWELLE®), chrome
Application process HVOF, high-velocity oxy-fuel spraying
Max. roll body dimensions ø 620 × 3,000 mm
Max. weight 3.5 t
Testing DIN EN ISO 9001:2015
Certificates CE, ASME
Comparison of a worn and a freshly reground flute profile

The purchase price is the smaller number.

The price over the service life

A corrugating roll costs money once when you buy it and continuously while it runs: a take-up factor that is too high, too much waste after downtime, poor heat transfer or too much vibration limiting speed. Over the life of a set, the purchase price is the smaller item. It is just the only one that appears on the quote.

Cost efficiency in detail

Three details are enough.

Your enquiry

Machine type, flute type, working width. That lets us assess what suits you, and we will get back to you with specific questions. If you have profile data or documents for your current roll, please attach them.

What is the sum of 4 and 5?

What buyers ask us first.

Frequently asked questions

Most enquiries revolve around the same points: regrinds, special profiles and whether a new roll is needed at all. Here are the short answers. If your question is not among them, get in touch directly.

In the single facer of a corrugator, a corrugating roll turns flat paper into the fluted structure. Two heated rolls work against each other and emboss the profile that later gives the corrugated board its stiffness.

Over the life of a set, our rolls usually allow four, in some cases even five, regrinds instead of three. An inspection tells you how many are still possible on your roll.

Yes. We design the roll geometry individually to suit material, process and application. 140,000 documented flute profiles and 104 known single facer types form the basis for this.

Often, yes. If the roll body and bearing seats are in good condition, we regrind the profile and recoat it. After the inspection, we tell you what is possible.

As a German manufacturer of corrugating rolls, we supply corrugated board plants on every continent. Alongside corrugating rolls for single facers, we manufacture special rolls and industrial rolls for related applications, all with the same in-house production depth in Föritztal.